Adhesive

Sure Stick Adhesive is designed to adhere EMC Rubber Tile Products to the approved substrate. It can be used to fully adhere the entire safety surfacing assembly or around the perimeter in combination with Klips or Konnector Pins to provide a complete system attachment. 

Advantages

  • Sure Stick Adhesive is a one part adhesive requiring no mixing prior to use.
  • Sure Stick Adhesive can be accelerated to reduce set up time and speed project installation.
  • Sure Stick Adhesive is fully compatible with all EMC Rubber
  • Safety Tiles providing a sure stick to the approved substrate.
  • Sure Stick Adhesive is available in 1 gallon or 5 gallon buckets providing easy to carry containers in quantities that minimize waste.
  • Sure Stick Adhesive can be ordered and shipped with your tile order insuring it available on the job when you need it and eliminating the hassle of dealing with multiple vendors. 

Storage

  • Use only with adequate ventilation.
  • Keep container tightly closed. Store in a cool, dry and well-ventilated area.
  • Refer to manufacturer MSDS for further information.

Storage & Coverage

  • Packaging: 1gal, 5gal
  • Sure Stick Adhesive covers approximately 55 square feet per gallon.

Installation


The substrate should be clean and dry. Insure that the rubber tiles to be installed are clean and dry. Moisture acts as an catalyst to the Sure Stick Adhesive so dry mats and surface are essential.  The minimum temperature for installation is 50° Fahrenheit and rising. Do not open the container until immediately prior to use. Adhesive is spread over the substrate in a thick , film coating being sure to cover all areas that will receive adhered tiles.


Allow the Sure Stick Adhesive to “tack” prior to setting the rubber tile. “Tacking” can be accelerated with a “fine” misting of water to create a catalytic reaction to speed the process. When using water to accelerate curing small “bubbles” will appear indicating the adhesive is ready to receive the tiles.


Final cure time is dependent on temperature, humidity and can be as short as 4 hours in high temperature, high humidity conditions or as long as 30 hours in lower temperatures with lower humidity. Refer to the product specific installation recommendations for further installation guidelines.

Pins

  • Hard injection molded plastic for long lasting performance
  • Precision designed for tight locking fit with the factory molded inserts
  • Six ferrell design ensures tiles remain locked together